Download List

프로젝트 설명

smartmontools contains utilities that control and monitor storage devices using the Self-Monitoring, Analysis, and Reporting Technology (S.M.A.R.T.) system built into ATA and SCSI hard drives. This is used to check the reliability of the hard drive and to predict drive failures. Version 5.x is designed to comply with the ATA/ATAPI-5 specification. Future releases will comply with the ATA/ATAPI-6 and ATA/ATAPI-7 specifications. It is meant to be an up-to-date replacement for the ucsc-smartsuite and smartsuite packages, and is derived from that code.

System Requirements

System requirement is not defined
Information regarding Project Releases and Project Resources. Note that the information here is a quote from Freecode.com page, and the downloads themselves may not be hosted on OSDN.

2009-12-11 03:43
5.39

많은 버그수정, 기능 개선 및 기타 변경됩니다.
Many bugfixes, feature enhancements, and other changes.

2008-03-17 15:10
5.38

많은 향상되었다.
Tags: Major feature enhancements
Many enhancements were made.

2004-03-07 06:54
5.30

NetBSD 등 및 Windows (Cygwin에서) 지원이 추가되었습니다. ATA는 Solaris 용 / IDE를 지원 / SPARC에서이 추가되었습니다. 지금은 오프라인 smartd 즉각적이고 자체 검사 계획을 실행할 수있습니다. smartd 지시어 절전 모드 (잠이, 대기, 혹은 idle)에 따라 디스크를 스핀 업 방지하기 위해 추가되었습니다. 드라이브가 많이 추가되었습니다 knowndrives 테이블. 거기에 각종 추가 및 수정했다.
Tags: Major bugfixes
NetBSD and Windows (Cygwin) support has been added. ATA/
IDE support for Solaris/SPARC has been added. smartd can
now run scheduled offline immediate and self-tests. A smartd
directive was added to prevent disk spin-up depending upon
the power mode (SLEEP, STANDBY, or IDLE). Lots of drives
were added to the to knowndrives table. There were various
other additions and fixes.

2003-10-28 23:06
5.22

smartctl '- T는'verypermissive 옵션을 5.21 오타로 인해 깨진했다. Linux 용 smartd DEVICESCAN 로직을 개선했습니다. 실험 솔라리스 포트 (SCSI 추가되었습니다에만 해당).
Tags: Major feature enhancements
The smartctl '-T verypermissive' option was broken in 5.21 due to a typo. The smartd DEVICESCAN logic for Linux was improved. An experimental Solaris port has been added (SCSI only).

2003-10-15 19:12
5.21

실험 FreeBSD를 포트, - F를 samsung2 플래그 바이트를 스왑의 펌웨어를 수정 (모든 삼성 드라이브 *- 23 펌웨어 버전을 문자열)를 적용, 시험에 대한 예상 완료 시간이 추가되었습니다 현재 인쇄 위치가 추가되었습니다. 유의하시기 바랍니다 소스의 익명 CVS 서버 동기화 거의 2 일간되었습니다. 지금은 간단히 tar 압축 다운로드합니다.
Tags: Major feature enhancements
An experimental FreeBSD port has been added, an -F samsung2 flag has been added to correct firmware byte swap (applies to all Samsung drives with a *-23 firmware revision string), and estimated completion time for tests are now printed. Please note that SourceForge's anonymous CVS has been out of sync for almost 2 days. For now, download the tarballs.

Project Resources